Ic40 reading zero salt level
2 posts / 0 new
Last post
Posted

Hello. I have Encountered a problem recently with my ic40 system that’s is connected to an easy touch 8 panel. The red light comes on for the salt level. Screen logic is reading zero salt when the level is at least 3200 tested. However when I turn off power to my entire system from easy touch panel, reboot it, and the ic40 re-calibrates it registers the Proper salt reading. The pool temperature is kept between 87 to 90°. I’m not sure what the problem is. I assume if it was this flow switch then it would not create the proper salt reading up on recalibration. Any help would be greatly appreciated. Thank you

Please Sign In to post comments
Richard's picture
Tech, Pentair
You may need to have your
Richard's picture
Tech, Pentair
Posted

You may need to have your water chemistry checked out and make sure that all is within range of the Pentair requirements. Having one of the agents maybe out of range, click on the link below and go to page 10 for your requirements.

https://pentairpool.com/~/media/websites/pool/downloads/sanitizers/manua...

Please Sign In to post comments