IntelliChlor Salt Sensor
7 posts / 0 new
Last post
Posted

My IntelliChlor IC40 is reading salt levels about 1000 ppm higher that other measurements (salt strip or Taylor Salt test drops).
Is the salt sensor replaceable? If so, what is it's part number?

Please Sign In to post comments
Richard's picture
Tech, Pentair
Unfortunately the salt sensor
Richard's picture
Tech, Pentair
Posted

Unfortunately the salt sensor in no replaceable, check and make sure the rest of your chemicals are within range to verify the required chemical levels, if the salt light is showing red and your actual salt level is within the required range, the cell should be operating properly, for details on water chemistry requirements, please see page 10 in the link below.

http://www.pentairpool.com/pdfs/IntelliChlorElectronicChlorineGeneratorN...

Please Sign In to post comments
Hi There. I think I need to
Posted

Hi There. I think I need to replace my salt chlorinator cell as it is flashing green and I have cleaned the cell 3x without success. I see a Canadian version (520912) and a US version (520555). Is there any difference between the two as there is a price gap. Thanks.

Please Sign In to post comments
I have the opposite problem
Posted

I have the opposite problem as John Becker. My Intellichlor is reading 2600 PPM but strips and electronic meter are both reading in the range of 3700. My intellichem is is doing a good job keeping the pH and ORP in balance. I tried to clean the salt generator earlier this year and scale buildup was not too bad and did not change the salt readings. Should I just ignore the bogus Intellichlor warning?

Please Sign In to post comments
Gus, What is your water
Posted

Gus, What is your water temperature?

Please Sign In to post comments
Well, it's getting late in
Posted

Well, it's getting late in the season and the water is only 71 to 73 degrees. Previous normal salt readings during the summer were in the low 80's.

Please Sign In to post comments
I have the opposite problem
Posted

I have the opposite problem as John Becker. My Intellichlor is reading 2600 PPM but strips and electronic meter are both reading in the range of 3700. Have a look at http://www.simonsholidays.us ; http://www.simonsholidays.uk and http://www.simonsholidays.com/ke ; http://www.simonsholidays.com/ad ; http://www.simonsholidays.com/be ; http://www.simonsholidays.com/nep ; http://www.simonsholidays.com/go ; http://www.simonsholidays.com/gt ; http://www.simonsholidays.com/ti and http://www.simonsholidays.com/y
which is best.

Please Sign In to post comments