Screelogic 2 Help!
4 posts / 0 new
Last post
Posted

Hello,

I have recently installed a complete Pentair system with the Intellitouch I7+3 personality board. I am having issues with the Screelogic 2 interface. My app and PC find the protocol adapter on the network but it doesn't seem to be communicating with the pool controller. Any help would be appreciated.

Thanks,
Phil

Please Sign In to post comments
Richard's picture
Tech, Pentair
Start with unplugging the
Richard's picture
Tech, Pentair
Posted

Start with unplugging the power from the transceiver, wait about 30 seconds then plug it in, if not you will need to check if both tx and rx lights are blinking? What can cause this issue also can be if the devices are not within a range where they cannot see each other or the outdoor receiver is mounted too close to your pool equipment such as the outdoor control panel, this can cause an interference and interrupt communication due to radio frequency changes. A simple relocation of the receiver can fix this issue?

Please Sign In to post comments
Thanks,
Posted

Thanks,

I will try this once all the rain stops!!!

Please Sign In to post comments
It worked. Thanks for the
Posted

It worked. Thanks for the info.

Please Sign In to post comments