Screen Logic flow rate does not reflect pump not running and how do I programming the fill function
2 posts / 0 new
Last post
Posted

I have to problems I could really use some help with.

1. for some reason today my screen logic power usage and RPM does not update when the pump is shut off. Both stay at the last value and do not go to zero as they used to.

2. How do I program a fill and drain button into my screen logic?

Thanks for your help.

Please Sign In to post comments
Richard's picture
Tech, Pentair
The rpm and power usage
Richard's picture
Tech, Pentair
Posted

The rpm and power usage should go to zero when the pump if shut off unless there is a separate circuit is running? Attempt to power down the entire system by cutting off the breakers and turning them back on after they have been down for about 1 minute.

Fill and drain are only operated in service or time out mode from the outdoor panel. No control from screenlogic. You can set up a circuit function as a spillway function as a type of fill function, but draining is not an option as a circuit function to prevent any accidental draining.

Please Sign In to post comments