ScreenLogic wireless stopped working
2 posts / 0 new
Last post
Posted

I have my ScreenLogic interface adapter connected to a ScreenLogic wireless module inside my house and antenna module at the equipment pad. It has worked fine for the last two years, but this year when I opened the pool it is no longer working. I can see and connect to the inside protocol adapter on my network, but I get no data from the equipment pad. I also have a MobileTouch controller that works perfectly fine at the exact same distance with no issues at all... separate antenna at the pad, obviously. The ability to troubleshoot the wireless connection and devices on both ends is poor to say the least. No documentation on what the lights indicate... or how to narrow down where the issue lies. Any advice would be greatly appreciated.

Please Sign In to post comments
Some more details...
Posted

Some more details...
1) When I try to turn a feature on or off in the iPhone app, the Rx light on the inside wireless receiver module flashes... but I never see the Tx light flash.
2) The outdoor antenna module Tx light seems to always be flashing... but never the Rx light.
3) If I unplug the power from the inside wireless module (not teh protocol adapter... the wireless module), the iOS app will not connect... but when I plug power back in, it then connects. Does this indicate SOME communication is taking place with the control panel, OR does the wireless adapter power the 422 lines and the protocol adapter does not allow connection if it does not wee 422 power?

When all is powered on, and the app connects, I get NO data... no current temp... no control of pumps... all information is OLD... like it was cached in the protocol adapter from last year... ie. chlorinator % is where I had it set at end of last season.

The MobileTouch controller works 100% with all current information on it's separate wireless link.

I need to know if this sounds like transmitter issue on one end or something else?

Please Sign In to post comments