ScreenLogic2 and default pool to be a "spillway"
4 posts / 0 new
Last post
Posted

I'm trying to figure out how to configure my pool to default as a "spillway" [where it takes water out of the pool and puts it into the attached spa].

The "pool" circuit only allows me to configure it as a pool. I added a "pool" feature; which I configured as a spillway and shown in the Pool Section. However, now I have two "pool" buttons in the pool section. And, if I change the pool circuit to "Don't show", the entire pool section is removed [i.e. even the pool feature doesn't show].

Is there a way to have a single "pool" button that's configured as a spillway?

Please Sign In to post comments
David MacCallum's picture
Pentair
Hi Todd, create a new feature
David MacCallum's picture
Pentair
Posted

Hi Todd, create a new feature circuit called Spillway and assign it with a Spillway circuit function. Then when this turns on manually or via scheduled program, it will rotate the valves and turn on the filter pump.

Please Sign In to post comments
David MacCallum's picture
Pentair
Also, assign this circuit to
David MacCallum's picture
Pentair
Posted

Also, assign this circuit to "show on" the Pool page.

Please Sign In to post comments
Is there someone who can
Posted

Is there someone who can address the "if I change the pool circuit to "Don't Show", the entire pool section is removed"? This behavior of the PC interface is especially annoying to me as I never run my pool in 'pool only' mode.

Please Sign In to post comments