Hello,My system is running fine, however, I would like to set up two schedules (currently have one schedule running with solar heating when available), one from 8:30am to 1:00pm with solar heat if available and one from 1:00pm to 3:30pm without any solar heat.  I tried setting up a 'high' and 'low' schedule with solar on high and not on low with corresponding schedules as above but the system was not operating as desired. Am I doing something wrong? What is the easiest way to accomplish…See More

Hello everyone.My solar system (intelliflo, suntouch) is operating and seems to be doing a pretty good job.  However, when the pool approaches the set temperature, the solar system turns on and off repeatedly after only several seconds to a couple minutes.  I have my pool set temp set to 32c, solar on temp diff to 6 and solar off temp diff to 2.  I've played with these settings a bit, but still have the problem.  Could it be the solar sensor placement or something else?  I'm not sure what to do…See More

HelloYesterday I just upgraded to the new Intelliflo VS pump and Suntouch controller.  Programing the controller is a little confusing given my setup.  It is as follows:- pool only, no spa- solar collectors on roof- solar actuator connected to valve C- solar and water sensors attached to Suntouch- Intellichlor IC-15 (no comm available to panel)Since the IC-15 cannot be directly wired to the Suntouch, power to Intellichlor provided by elec. outlet wired to Suntouch relay connected to Aux 1.The…See More