EasyTouch v2.160 issues with IntelliFlo VSF
2 posts / 0 new
Last post
Posted

I have a brand new EasyTouch 4 (firmware v2.160) and IntelliFlo VSF pump. Comms is all working fine, however I have the following issues:
- Any GPM flow rate programmed on the EasyTouch is ignored by the VSF pump. RPM programs work fine, and GPM *set on the pump* works fine. Its just specifically GPM set on the EasyTouch that is ignored.
- None of the standard IntelliFlo settings are available on the EasyTouch (e.g. "Priming", "Backwash", "Vacuum" etc). The only options I have are "Flows/Speeds" and "Status"

I see that latest firmware is actually v2.180 and has the following fix: "Fixed several issues with the VSF pump"

Can anyone confirm if the 2.180 update is intended to fix the same issues I have?

Thank you

Please Sign In to post comments
Richard's picture
Tech, Pentair
As long as you have the "VSF"
Richard's picture
Tech, Pentair
Posted

As long as you have the "VSF" pump and you have the type set to VSF you should not have any issues running your pump in vsf type, it is not known at this time if 2.180 will fix the issue, you may want to contact one of our representatives regarding this issue at 1-800-831-7133

Please Sign In to post comments