I have recently purchased a Screenlogic interface and wireless connection kit. My preference would be to hard wire the protocol adapter but running a new line out to the pool would be too much trouble.
The installation instructions say:
"Note: Optional wiring for existing Indoor Control Panel. Tap into the indoor Control Panel connector or pigtail off the four-wire cable connected to the Control System Board"
I have an indoor control panel. Does the above mean that I can simply pigtail onto the existing line currently in use (i.e. both the Indoor Control Panel and the protocol adapter would share the same line out to the Intellitouch Control System Load Center)? The manual says nothing about what wiring changes this setup would require (if any) on the system circuit board; the only diagram shows 2 separate lines attaching to J7 and J8, but I'm not sure that this is a requirement.
Any advice would be gratefully received.